On-and-off wind, solar power take toll on coal plants
https://www.businesstimes.com.sg/energy-commodities/on-and-off-wind-solar-power-take-toll-on-coal-plants
Coal plants that were built to operate around the clock are now sometimes relegated to supplying power
THE Gentleman coal plant was once the linchpin of Nebraska’s electricity grid, its twin smokestacks visible for miles across the prairie. Now, the state’s biggest power source is routinely pushed aside to make room for more wind and solar energy.
Operators ramp it down and then bring it back up again, often on a daily basis. That’s not how coal-fired power plants are supposed to be used – they respond more like oil tankers than speed boats – and the stress is taking a toll on the ageing equipment.
The shift comes as a response to cheap natural gas and the growing use of wind and solar. All that intermittent power is forcing power providers to change the way they manage their fleets, and coal plants that were built to operate around the clock are now sometimes relegated to supplying power when the wind fades or the sun goes down.
“These plants were designed to run at, or near, full capacity,” said Mick Spencer, a plant manager for Nebraska Public Power District, which operates the Gerald Gentleman Station near Sutherland, Nebraska. “We aren’t doing that much anymore.” The Gentleman plant has 1,365 megawatts of capacity, and burns as much as 800 tonnes of coal an hour when running at full strength. That’s not as common as it used to be. In April, the plant’s average daily output fell to 201 megawatts, about 15 per cent of its total capacity, according to data compiled by Bloomberg. It hasn’t exceeded 1,300 megawatts since the beginning of the year. The dip in April was partly because the plant was shut down for maintenance, the utility said.
The facility is almost four decades old, and the swings in output can tax the equipment, Mr Spencer said. The state-owned utility is seeking to minimise the impact, including replacing parts more frequently and scheduling inspections more often.
It’s either that or shut down for good. Almost 40 per cent of the US coal fleet has been shuttered or targeted for closure since 2010, either because they’re no longer profitable to run or require significant investments to meet environmental rules, according to the American Coalition for Clean Coal Electricity, a trade-group that represents utilities and mining companies.
“It’s very difficult for coal to compete in states like Nebraska and Iowa and North Dakota, where wind energy can reach over 50 per cent of supplies,” said Todd Hagist, an analyst at Genscape. “This trend is spreading and it’s permanent. Wind isn’t going away.”
General Electric Co, which provides coal-power equipment around the world, is seeing more customers operating the facilities in new ways, according to Michael Keroulle, chief commercial officer for GE’s steam power unit. These companies typically are looking for ways to maximise revenue, as cheaper alternatives mean coal power often isn’t competitive during parts of the day. In some cases, they’re choosing to run the plants “closer to their limits,” he said.
“It’s a big deal and a growing theme over the past three or four years,” Mr Keroulle said. “Forty years ago there was no influx of intermittent energy. Now, they can make more money when the renewables are down.”
AES Corp, which provides power in 15 countries, is also adjusting the way it operates coal power. “It’s more difficult on the plant,” said chief executive officer Andres Gluski, who estimates that ramping a facility’s output up and down can could take a decade off its useful life.
Utility giant American Electric Power Co, once the largest US coal consumer, has throttled back on some coal plants it still operates, and plans to gradually replace them with a combination of solar, wind and other energy sources, said Mark McCullough, executive vice-president of generation at AEP. Many facilities that “used to run flat out” now operate closer to 50 per cent.
Increasing and decreasing output more frequently “does add a bit to wearing things down,” he said. “You’re moving valves and parts more than you did. You have to be aware of the long term impact” of changing temperatures on steel. BLOOMBERG